No scrape. No scuff. No noise.Free US shipping until Dec 31

Furniture Sliders

Furniture sliders go under the legs of a sofa, bed, dresser or table so you can push the piece across the room instead of lifting it. Both sliders here sit loose under the leg, with a smooth plastic base on the floor and a black foam top against the leg, and they come out again when the move is done.

For a big move, the furniture moving sliders come 12 to a pack, each 3.5 in (89 mm) round, enough for three four-legged pieces at once. For one smaller piece, the reusable furniture sliders are 4 hexagons about 3.1 in (80 mm) across, one for each leg.

To pick a size, measure across the bottom of one leg. Our guide on how to measure chair legs for protectors works for any leg or foot. Want something that stays on the leg for good? See chair glides.

How to choose furniture sliders

Choose by the size of the leg and the number of legs you move at once. The whole bottom of the leg should rest on the foam top.

Slider Size Fits legs up to Pack
Furniture moving sliders 3.5 in (89 mm) round Round about 3 in (76 mm); square about 2 in (5 cm) 12
Reusable furniture sliders About 3.1 in (80 mm) hexagon Round about 2.4 in (6 cm); square about 1.75 in (4.5 cm) 4

Both have a smooth plastic base and a black foam top. Both sit loose under the leg with no adhesive, and both slide on carpet, and on hard floors once the floor is swept.

How to measure the leg

  • Tip the piece a little or lift one corner, then measure across the bottom of a leg, where it touches the floor. Do not measure the wider part higher up.
  • Square legs: measure one side. The hexagon sliders take square legs up to about 1.75 in (4.5 cm) on a side, and the 3.5 in rounds up to about 2 in (5 cm). A bigger square leg overhangs the foam on both.
  • Bun feet and wide sofa feet vary, so measure them first. A foot wider than about 3 in rests partly on the plastic rim of the round slider, and a foot wider than 3.5 in (89 mm) hangs over the edge.
  • Count the legs. You need one slider per leg, so a sofa with 6 legs needs 6 sliders.

How to use furniture sliders

  1. Empty drawers and shelves first. A lighter piece is easier to tip and push.
  2. Tip the piece a little and set one slider under each leg, black foam side up, smooth plastic side down.
  3. Push low, near the base of the piece. Pushing from the top can tip a tall dresser or bookcase over.
  4. When the piece is in place, tip it again and take the sliders out.

Furniture sliders for carpet

A hard, smooth plastic base glides over carpet pile, which is the job these sliders are made for. On carpet you can set them down and push without sweeping first.

Furniture sliders for hardwood floors

Both sliders also slide on hardwood, laminate and tile. Sweep or vacuum the path first, and wipe the base of each slider: a grain of grit trapped under hard plastic can scratch a hard floor as the piece moves. Tip the piece onto the sliders rather than dragging a leg onto one. Felt-bottomed sliders are the usual pick for finished wood. Ours are hard plastic, so on wood the sweeping and wiping step matters most.

Honest limits

  • These are for moving furniture, not for leaving under it. They are loose, so they slip out from under a chair that is pulled in and out every day. For chairs, chair sliders stay on the leg.
  • The supplier does not state a maximum load for either slider. Empty drawers and shelves first, and ask a second person to steady a tall or heavy piece, such as a full wardrobe, while you push.
  • For pads that stay under a sofa or table on a wood floor, see furniture pads for hardwood floors.

Furniture Sliders: questions and answers

What are furniture sliders?

Pads that go under a furniture leg so you can push the piece instead of lifting it. They come out again when the move is done.

Carpet or hard floors?

Both. The smooth plastic base slides on carpet and hard floors; the foam top cushions the leg. Sweep grit off a hard floor first, because grit trapped under hard plastic can scratch.

Which size do I need?

One whose foam top is at least as wide as the bottom of the leg. The <a href="/products/reusable-furniture-sliders">reusable furniture sliders</a> (hexagon, about 3.1 in or 80 mm) fit round legs up to about 2.4 in (6 cm) and square legs up to about 1.75 in (4.5 cm). The <a href="/products/furniture-moving-sliders-12-pack">furniture moving sliders</a> (round, 3.5 in or 89 mm) fit round legs and feet up to about 3 in (76 mm) and square legs up to about 2 in (5 cm).

Do sliders stay on the furniture?

These do not. They go under the legs while you move the piece. For something that stays on the leg, see <a href="/collections/chair-sliders">chair sliders</a> for chairs or <a href="/collections/furniture-pads-for-hardwood-floors">furniture pads for hardwood floors</a> for sofas and tables.

How many sliders do I need?

One per leg. The 12 pack covers three four-legged pieces at once, or one sofa with up to 12 legs. The 4 pack covers one four-legged piece.

Can I reuse them?

Yes. Nothing sticks or screws on, so you take them out after the move and keep them for next time.

Cart • 1 item

Loading your bag…