Non Slip Furniture Grippers
4 clear silicone pads, 3 mm thick, one pack
$19.99 · Free US shipping until Dec 31
Clear silicone pads that go under sofa, bed and table legs to stop furniture creeping on hard floors. Choose round or square, 60 or 80 mm wide, with four pads in every pack.
- 4 clear silicone pads, 3 mm thick, in every pack
- Round or square, 60 or 80 mm wide
- Peel off the clear film and press onto the leg base
- For sofa, bed and table legs on hard floors
Not happy, or the wrong size? Email us within 30 days of delivery and we refund you. No need to send anything back.
- Secure checkout: pay with PayPal, Shop Pay or card
- Free tracked US shipping until Dec 31, 2026. Estimated delivery 6 to 14 business days after you order
- 30-day refund policy · Size guide
Non slip furniture grippers keep sofas, beds and tables where you put them on hard floors. Each pack holds four clear silicone pads, 3 mm thick, in round or square and 60 or 80 mm wide.
One pad goes under each leg, so soft silicone sits between the leg and the floor and the piece is much less likely to creep when someone sits down or leans on it. Because the pads are clear, the floor shows through and they are hard to spot.
These grippers are part of our chair stoppers range, next to raised furniture cups for appliance and furniture feet. For pads that let furniture slide instead, see all floor protectors.
Sizes and what is in the pack
| Shape | Pad size | Pads |
|---|---|---|
| Round | 60 mm (2.36 in) across | 4 |
| Round | 80 mm (3.15 in) across | 4 |
| Square | 60 x 60 mm (2.36 x 2.36 in) | 4 |
| Square | 80 x 80 mm (3.15 x 3.15 in) | 4 |
Every pad is 3 mm (0.12 in) thick and clear. The round pads have a raised spiral line on the face and the square pads have raised octagon rings. One pack covers one four-legged piece. A sofa or bed with six or eight legs needs two packs.
How to choose the right size
Lift one leg and measure the bottom of the leg where it touches the floor. Choose a pad at least as wide as that base, so the whole foot sits on silicone:
- Leg base up to about 55 mm (2.2 in): 60 mm pad.
- Leg base up to about 75 mm (3 in): 80 mm pad.
- Wider than 75 mm (3 in): the foot would hang over the edge of even the 80 mm pad, so these pads are not the right fit.
Match the shape to the leg. Round pads suit turned and tapered legs, square pads suit square legs. A round leg also sits fine on a square pad; it just leaves a wider clear border at the corners. A square leg on a round pad needs a pad wider than the leg measured corner to corner, or its corners hang over the edge.
How to fit them
- Wipe the bottom of the leg and the spot on the floor, and let both dry. Dust between the pad and the floor reduces grip.
- Peel the thin clear film off the pad.
- Press the pad onto the center of the leg base, or lay it on the floor and lower the leg onto its center.
- Set the furniture down so every leg sits fully on its pad.
If a piece starts to move again, lift each leg, wipe any dust off the pad and the floor with a dry cloth, and set the leg back down. If it still creeps, our guide on how to keep furniture from sliding on hardwood floors covers cups for round feet and wheel stoppers for office chairs.
Where they work and where they do not
The grippers are made for smooth, hard floors: hardwood, laminate, vinyl plank and tile. They suit furniture that should stay in one place, such as sofas, beds, sideboards, TV stands and dining tables. Silicone grips a smooth floor much better than bare wood or felt does, so furniture standing on these pads is far less likely to creep across the floor.
They are the wrong choice for chairs you pull in and out every day, because they are designed to stop movement. For those, chair leg caps or felt furniture pads let the chair slide while still protecting the floor. The pads are flat, so they do not hold a caster wheel. They also raise each leg by 3 mm, which is too little to notice on most furniture.
Questions
What do non slip furniture grippers do?
They put a clear silicone layer between each leg and a hard floor, so sofas, beds and tables are much less likely to creep when someone sits or leans on them.
Which size do I need?
Measure the bottom of the leg and pick a pad at least as wide as it: 60 mm (2.36 in) for leg bases up to about 55 mm, 80 mm (3.15 in) for bases up to about 75 mm. The size table above lists every option, and our guide on how to measure chair legs for protectors shows how to measure.
Round or square?
Match the shape of the leg base: round for turned or tapered legs, square for square legs. A round leg also sits on a square pad, but a square leg only fits a round pad that is wider than the leg measured corner to corner.
How many come in a pack?
Four grippers of one shape and size, enough for one four-legged sofa, bed or table. Furniture with six or eight legs needs two packs.
How do they go on?
Peel the thin clear film off, then press the pad onto the clean bottom of the leg, or lay it on the floor and lower the leg onto its center.
Can I use them on chairs I slide in and out?
No. They are made to stop movement. For chairs you move every day, chair leg caps let the chair glide while still protecting the floor.











